Repair damage with less surface disturbance
Reduced digging where suitable
We repair from within when the existing pipe can support a liner.
Careful pipe preparation
We clean and prepare the internal surface before installing the lining.
Condition-led advice
We check whether relining is suitable instead of assuming it will work.
Repair suitable drains from the inside
Digging down to a damaged drain can affect paving, landscaping or other surfaces above it. Where the existing pipe retains enough integrity, we may use no-dig drain relining to repair suitable cracks, gaps and weakened sections internally. The process creates a new structural lining within the old drain, sealing the affected area without exposing the whole pipe from above. We first inspect the drain and assess the position and extent of damage. Relining can reduce excavation and reinstatement, but it is not the right answer for every defect. We recommend it only when the pipe condition and access support a dependable internal repair.
Prepare, install and check the liner
A suitable drain must be cleaned and prepared before lining so debris does not prevent a sound result. We inspect the route, clear the internal surface and prepare the liner for the damaged section. Once installed, the lining is cured to form the new internal structure. We then check the route and confirm that flow can pass through it. A collapsed pipe or a section with too little remaining integrity may require direct replacement instead. By comparing relining with excavation and local repair, we can explain which approach best fits the fault and the level of surface disruption involved.
Frequently asked questions
What damage can drain relining address?
Relining may seal suitable cracks, gaps and weakened sections where enough of the original pipe remains intact. The position and extent of damage matter. We inspect the drain first because a collapse or severe displacement may require excavation instead.
Does no-dig relining avoid all excavation?
It can reduce or avoid digging along the damaged run, provided access and pipe condition are suitable. Some jobs may still require access work. We explain the likely level of disturbance once we've inspected the drain and planned the installation.
What happens before the liner is installed?
We inspect and clean the pipe, then prepare the internal surface and lining. After installation, the liner is cured to form a structural repair. We finish by checking the route and confirming that water can flow through the repaired section.